Use and maintenance of steam emulsification tank

Here are the key steps for using and maintaining emulsification equipment:

### 1. **Instructions for Use**

- **Cleaning Before Use**: Clean the reservoir with fresh hot water and sterilize it with steam before use.

- **Filling the Tank**: Fill the tank with the slurry through the material pipe on the tank cover or by opening the cover and pouring it in. Avoid overfilling to prevent splashing during agitation, which could lead to unsanitary conditions or damage.

### 2. **Heating Method**

- **Preparation**: Before heating, drain any remaining refrigerant from the jacket, then start the agitator and open the steam valve.

- **Temperature Control**: Once the desired temperature is reached, close the steam valve and wait 2-3 minutes before stopping the agitator.

### 3. **Insulation**

- **Maintaining Temperature**: Use the agitator and high-speed valve to maintain the desired temperature, checking the thermometer to ensure proper insulation.

### 4. **Cleaning**

- **Post-Processing**: After processing, drain any remaining condensate from the jacket and rinse the tank with warm water to remove sticky material.

- **Alkaline Cleaning**: Clean the inner walls with alkaline water (40°C to 50°C) and rinse with clean water.

- **Disinfection**: Before the next use, disinfect the container with hot water (90°C or higher) for 2-3 minutes.

### 5. **Maintenance**

- **Equipment Monitoring**: Regularly check the equipment and reducer for proper operation.

- **Lubrication**: Refill the reducer lubricant if necessary and change the oil (40# engine oil) every six months.

- **Rust Prevention**: When the equipment is not in use, rinse the jacket with warm water to prevent saltwater corrosion.

- **Exterior Cleaning**: Regularly scrub the tank to keep it clean and shiny for long-term durability.

By following these steps, the emulsification equipment can be used efficiently and maintained for optimal performance.