Debugging method of electric heating reactor

To debug an electric heating reactor, follow these steps:

1. **Installation**:

- Place the reactor on a sturdy, flat surface with sufficient space for installation and maintenance.

- Ensure the equipment is vertically aligned, with no tilt greater than 1/1000 of its height.

- Connect all components, including spare parts and safety valves, according to the reactor's process requirements.

2. **Inspection**:

- Check the robustness of connection and transmission components.

- Test the airtightness of all connecting pipes and nozzles to prevent leaks, foaming, or dripping.

3. **Pre-operation Checks**:

- Turn on the motor and inject the reductant into the oil shield.

- Manually rotate the fan blades to ensure there is no idle motion.

- Clean the impeller wall to remove any dirt before starting the process.

4. **Initial Operation**:

- Run the reactor for 30 minutes without noise or vibration.

- Begin feeding the reactor only after confirming smooth operation.